Pressing a finished tee

An operator presses the rib V-neck of a finished cream tee with an industrial iron on the pressing table at Collective Studio in Narayanganj, Bangladesh.

Length
0:14, no sound
Filmed at
Collective Studio, Narayanganj, Bangladesh

What you are seeing

Pressing comes near the end of finishing, before a garment is folded and bagged. It sets the knit flat and square, so the neckband, the side seams and the hem sit straight when the piece goes into its bag.

The clip is filmed from above the operator's hands. A cream V-neck tee with dark green rib trim lies flat on the pressing table. One hand holds the rib neckband flat while the other runs the iron along it, down one side of the V and then the other.

In the longer footage this clip is cut from, the same tee is also turned over and its back pressed, and at the end it is measured with a tape. The measuring clip on the videos page shows that last step.

Finishing in the order of work

Finishing covers trimming loose threads, pressing and folding. It follows sewing and comes before the final inspection and packing. The whole sequence, from the brief to the carton, is set out in our step-by-step guide to the garment manufacturing process.

How a piece is folded and bagged belongs in the packaging section of your tech pack. The measuring clip shows this tee being measured after pressing, and the packing clip shows folding and bagging on the same floor.

Where this clip appears